EM-236 Interface Unit
EM-236 Interface unit is made for adjusting and copying adjustments of Electromen driver devices and for monitoring dynamic values during drive. EM-236 enables the searching of the right settings and adjustments for the aplication, and after that these settings can be reliably loaded to other units. EM-236 is handy in instrumentation and allso a simple tool in production.
The use in short: After the driver unit is powered the cable from EM-236 with red "Micro Match" connector is connected to the driver unit, (Notice the hole in board for polarity tab). The display of interface unit wakes up and after some anouncements it is ready to load up parameters from the target driver (Load&Edit), if there is need to edit, the values can be changed with + and - buttons. Then the parameters can be saved with 2 seconds push of the "2sec. save" button. If the operation of the driver is OK. the red connector can be connected to the next driver and with a push of "Copy to device" button the same parameters are loaded to the next unit and to as many units as the user desires.
Check other configuration tools, download brochure here.
|Supply 3-6V / 30mA|
|Baud rate 9600b/s ±10%|
|Display 2x16digits, LCD|
|Memory 5 slots, each can store|
|one set of parameters.|
|Lead lenght 180mm|
- 124 pcs. in stock
FAQ - Frequently asked questions
Cannot find the product information you are looking for?
Click here to open a form and send us a question.