Electronics

EM-236A Interface Unit

• * Accurate and easy adjustment
• * Good adjustment repeatability
• * Saves space in products
• * Gives economical advance

• * Enables dynamic monitoring
• * Easy to use
• * Smaller and lighter than EM-236
• * Replaces previous EM-236

EM-268 Module for Firmware Updates

• • OLD MODEL, only for spares
  • Use with EmenToolLite
  • Firmware update
  • Can use as USB-serial converter
  • Micromatch connector
  • 5V serial In/Out
  • FTDI series drivers

EM-326 Bt Dongle

• Parameters setting with iPhone.
• Easy connect

• Control devices
• Free Ementool app is available in App Store

EM-328 Interface unit series "dongle" for EmenTool Lite

• USB to serial converter
• EmenTool Lite compatible
• Three different choices
• Power supply to the target device
• Galvanic isolation version ( -ISO )

• Low cost version ( A )
• Replaces earlier dongle EM-268
• Link cable length 1m
• Replaceable link cable ( not in -A )

EM-328-ISO Interface unit series "dongle" for EmenTool Lite

• USB to serial converter
• EmenTool Lite compatible
• Three different choices
• Power supply to the target device
• Galvanic isolation version ( -ISO )

• Low cost version ( A )
• Replaces earlier dongle EM-268
• Link cable length 1m
• Replaceable link cable ( not in -A )

EM-328A Interface unit series "dongle" for EmenTool Lite

• USB to serial converter
• EmenTool Lite compatible
• Three different choices
• Power supply to the target device
• Galvanic isolation version ( -ISO )

• Low cost version ( A )
• Replaces earlier dongle EM-268
• Link cable length 1m
• Replaceable link cable ( not in -A )

EM-A1 OPTION CARD FOR SYMMETRIC CONTROL

• Can be used with products
• EM-151A
• EM-176A

• EM-206
• EM-282

EM-A14T-4 REMOTE CONTROL TRANSMITTER

• 433MHz frequency band.
• < 10mW output ( licence-free )

• Rolling code security ( KeeLoq )
• AM or FM options available

EM-A14T-FM REMOTE CONTROL TRANSMITTER

• 433MHz frequency band.
• < 10mW output ( licence-free )

• Rolling code security ( KeeLoq )
• AM or FM options available

EM-A14T-FM-4 REMOTE CONTROL TRANSMITTER

• 433MHz frequency band.
• < 10mW output ( licence-free )

• Rolling code security ( KeeLoq )
• AM or FM options available

EM-A14T2 REMOTE CONTROL TRANSMITTER

• 433MHz frequency band.
• < 10mW output ( licence-free )

• Rolling code security ( KeeLoq )
• AM or FM options available

EM-A18 + EM-A14 REMOTE CONTROL SYSTEM

• • Motherboard + receiver hybrid EM-A14R
  • KeeLog
  • Two outputs
  • Can be learned up to 16 transmitters

EM-A23 Braking Load Resistor

• Operating voltage 12-40V
• Idle current 10mA
• Switch on limit 18-39V adjustable
• Switch on current 5A at 25V supply
• Brake load 5ohm.

EM-A23-48V Braking load

• Operating voltage 33-65V
• Idle current 2mA
• Switch on limit 18-39V adjustable
• Switch on current 3A at 50V supply

• Brake load 15ohm.
• Hystersis typ. 10%
• Overtemp limit 130 °C

EM-A3-10K-A-O CONTROL POTENTIOMETER

• • Control Potentiometer
  • Automation applications

EM-A41 Supply Reduce and Emergency Relay

• -High current handling capacity
• -Low idle current
• -Hardware emergency switch off
• -Switch on with pilot current
• -Compatible for capacitive loads

• -Din rail mountable
• -Relay faulty output
• -Compatible with EM- motor drivers
• -Recuces power on current surge

EM-A43 Brake Resistor

• Operating voltage 12-60V
• Idle current 5mA
• Switch on limit 20-60V adjustable
• Switch on current typically 10-20A

• Brake load 1.4 / 5.6ohm.
• Overtemp limit 160 °C

EM-M66 RAMP GENERATOR

• Three way isolated
• Multiple output ranges
• 254 steps
• Dip-switch settable
• Multiple ramp speeds

• Zero and gain fine adjustments
• Isolation voltage 1000V
• Short circuit protected output
• Rail mountable

EM-P189 Serial TX/RX to RS-485 Adapter

• Operating voltage 4.5-6V ( powered with link cable )
• Idle current consumption 5mA
• Rs-485 Terminal resistor 120 ohm in socket, if needed

• Rs-485 Line bias resistors 10kohm
• Link cable Micro-Match to Micro-Match 25cm
• Weight with cable 28g

EM-T50-2R2-80W Power Resistor

• Resistance EM-T50-2R2-80W 2.2ohm
• Resistance EM-T50-4R7-80W 4.7ohm
• Nominal power duration 80W

• Peak power 500W ( 5s )
• Weight 165g

EM-T50-4R7-80W Power Resistor

• Resistance EM-T50-2R2-80W 2.2ohm
• Resistance EM-T50-4R7-80W 4.7ohm
• Nominal power duration 80W

• Peak power 500W ( 5s )
• Weight 165g