gbfisedeesfritpt

EM-243-PLI DC-MOTOR CONTROLLER 12-48V 50A

83,00 € /kpl

EM-243-pli is a full bridge DC-motor starter. It is designed to work with DC-motor in applications where some special functions are needed. Starter has adjustable acceleration and deceleration ramps, which make possible the smooth starts and stops. Adjustable current limit protects motor against overcurrent and it can also be used as an end-stop. This device has also two settable speeds, which are usefull in positioning applications. Control inputs FW and BW start the forward and backward run. STOP is for the motor shutdown. In -PLI version there are also PULSE COUNTER which can be used for end limit use. This counter value keep in memory of card also when power is turned off. SPEED-2 input activates preset speed-2, but it can also be used as input for analog speed control signal 0-5V. FAULT output terminal indicates different failure situations. This pin is normally high, but is pulled down in overheat and conditionally also in current trip situation. DISABLE input disables driver as long as this is pulled down externally. Also it is possible to link fault and disable pins of several units together and achieve a syncronous stop. The BRAKE output can be used to release external magnetic brake or control brake resistor in overvoltage situation.

There are two selectable control modes, continuous and impulse. In continuous mode the motor runs as long as the control is active. In impulse mode a short comand starts the motor, and only a new impulse will change the status. There is also few special settings start-kick and auto reverse. The card has selectable input logics. Inputs are divided in two groups, control and limit -inputs. Groups can be individually set for NPN or PNP logic. The parameters are set with EM-236 interface unit. Operation of the controller and some of its functional values can also be monitored with EM-236 interface unit.


EM-243-PLI

TECNICAL DATA EM-243-PLI prog. v2.2 / PCB -C


Supply voltage nominal 12-48V, limits 10-58V
Start up voltage 9V, shutdown voltage 8V
Idle current typ 15mA
Motor current max. with 2kHz pwm
100% pwm 50A , 20-99pwm% 35A and peak 100A ( 5s )
Motor current max. with 16kHz pwm
100% pwm 40A , 20-99pwm% 20A and peak 60A ( 5s )
Current limit adjustable 1-100A
NOTICE ! during start ramp the current limit is 50% boosted
Overheat limit 100°C
Start and stop ramp adjustable 0-5s
PWM frequency 2kHz or 16kHz
I-limit input scale ( stop ) 0-4V = 0-100A
Input control logic: high =4-30V, low=0-1V
Pulse input imped. typ 10kohm
Pulse input freq max. 1000Hz
Control input impedances typ. 10kohm
Control input response time typ 5ms.
Fault out. NPN open coll. max. 40V / 1A
Fault in actives Uin < 1V ( NPN )
Fan-output switch on 55°C, off 50°C ( only pcb Cv.2 of later )
Fan-output NPN max. 40V 2A
Break load output Max. 60V 5A
Vout lim output max 25V 15mA
Motor and supply connectors 2.5mm
Control connectors 1mm
Dimensions 107x73x40mm
Dimensions in DIN-rail base 110x80x55mm
CE-tested for industrial environment ( EMC )
Operating ambient temp ( Ta ) -40...60°C
Weight 190g

Tiedostot

Varastotilanne

  • Tiedustele saatavuutta.

Hinta

  • 83,00 € /kpl