EM-243C-JS1 DC-MOTOR CONTROLLER 12-48V 50A
EM-243C-JS1 is a full bridge DC-motor starter. It is designed for joystick controlled DC-motor applications. The driver has adjustable acceleration and deceleration ramps, which enable the smooth starts and stops. Adjustable current limit protects the motor against overcurrent and it can also be used as an end-stop. This device has also two settable speeds, separate speed ranges for forward and reverse direction. Control input is specially designed for joystick control. The joystick range calibration is done automatically, when
calibration function is activated. Calibration detects forward, reverse and midpoint positions. FAULT terminal has simultaneously both input and output functions, the pin is normally high, but is pulled down in overheat and conditionally also in current trip situation. If FAULT-line is pulled down externally it will cause a stop and prevent it from starting again. For example, it is possible to link fault pins of several units together and achieve a syncronous stop.
There are also special settings as start-kick which can be used in case the device is in danger of being jammed.
Limit input can be individually set for NPN or PNP logic.
The parameter's settings can be done with various EM- interface units. Operation of the controller and some of its functional values can also be monitored with interface units.
Supply voltage nominal 12-48V, limits 10-58V
Start up voltage 9V, shutdown voltage 8V
Idle current typ 15mA
Motor current max. with 2kHz pwm
100% pwm 50A ,
20-99pwm% 35A and peak 100A ( 5s )
Motor current max. with 16kHz pwm
100% pwm 40A ,
20-99pwm% 20A and peak 60A ( 5s )
Current limit adjustable 1-100A
Notice! current limit is increased 50% at start
Overheat limit 100°C
Start and stop ramp adjustable 0-5s
PWM frequency 2kHz or 16kHz ( selectable )
joystick input scale 0-5 or 0-10V ( if dip 1 is ON )
Input control logic: high =4-30V, low=0-1V
Control input impedances typ. 10kohm
Control input response time typ 5ms.
Fault out. NPN open coll. max. 50V / 1A
Fault in actives Uin < 1V ( NPN )
Brake output NPN max. 5A 60V
Fan output NPN max. 2A 40V
Motor and supply connectors 4mm
Control connectors 1mm
Dimensions in DIN-rail base 110x80x55mm
CE-tested for industrial environment ( EMC )
Operating ambient temp ( Ta ) -40...60°C
- EN_em-243C-JS1.pdf - Lataa tiedosto (777 kt)
- EM-243C_3D.zip - Lataa tiedosto (3093 kt)
- EN_em-Rail_bases.pdf - Lataa tiedosto (2834 kt)
- 9 kpl varastossa
83,00 € /kpl