gbfisedeesfritpt

EM-282D-JS1 DC-MOTOR CONTROLLER 12-48V 100A

156,00 € /kpl

EM-282D-JS1 is a full bridge DC-motor starter. It is designed for joystick controlled DC-motor applications. The driver has adjustable acceleration and deceleration ramps, which enable the smooth starts and stops. Adjustable current limit protects the motor against overcurrent and it can also be used as an end-stop. This device has also two settable speeds, separate speed ranges for forward and reverse direction. Control input is specially designed for joystick control. The joystick range calibration is done automatically, when calibration function is activated. Calibration detects forward, reverse and midpoint positions. FAULT terminal has simultaneously both input and output functions, the pin is normally high, but is pulled down in overheat and conditionally also in current trip situation. If FAULT-line is pulled down externally it will cause a stop and prevent it from starting again. For example, it is possible to link fault pins of several units together and achieve a syncronous stop.
There are also special settings as start-kick which can be used in case the device is in danger of being jammed. Limit input can be individually set for NPN or PNP logic.
This D-version has added Rs-485 serial port for Modbus communication possibility.
The parameter's settings can be done with various EM- interface units. Operation of the controller and some of its functional values can also be monitored with interface units.


EM-282D-JS1TECHNICAL DATA ( EM-282 pcb -D ver.1 prog JS1 v1.7 )

Supply voltage nom. 12-48Vdc (abs. limits 10-60V )
Shutdown voltage 10V
Overvoltage limit adjustable 15-60V
Idle current typ 20mA
Motor current max. cont. 100A ( at 24Vdc and 25°C amb. temp)
80A and 100A with fan installed ( at 24Vdc and 60° amb. temp )
-Motor currents are about 20% lower with 16kHz pwm freq.
-At 48V supply voltage motor current is typically 15% less
Braking load current (pin 16) max cont 50A peak 100A
Current limit adjustable 1-200A
NOTICE! current limit is 20% boosted during start ramp.
Over temp. limit 100°C
Start and stop ramp adjustable 0-5s
PWM frequency 2kHz / 16kHz
joystick input scale 0-5 or 0-10V ( if dip 1 is ON )
Input control logic: high =4-30V, low=0-1V
Control input impedances typ. 10kohm
Control input response time typ 5ms.
Fault out. NPN open coll. max 42V / 0.5A
Fault in. actives Uin < 1V ( NPN with 100k pull up)
Rs-485 bus, halfduplex, ModbusRTU, 9.6/19.2 kbps
Motor and supply connectors 16mm²
Control connectors 1mm²
Dimensions 180x122x60mm
CE-tested for industrial environment ( EMC )
Operating ambient temp ( Ta ) -40...60°C
Weight 750g

Tiedostot

Varastotilanne

  • 4 kpl varastossa

Hinta

  • 156,00 € /kpl