EM-LP40 power supply is designed to supply multiple EM-products. This device based on standard transformer, which advantage is high peak current capability. This power supply type is very suitable for DC-motor application where needed lot of current when starting motor. The one advantage of linear power is very low EMC - emissions. The output voltage of power is not regulated, but it is filtered,
Device transformer has thermal self-recovery fuse Housing is ABS plastic with PG outlets IP65. but not recommended for outdoor, because not UV- protected.
COMPABILITY FOR PRODUCTS
- EM-175
- EM-180 / EM-180A
- EM-241 series
- EM-269A
- EM-291A
- EM-295
- EM-296
- EM-324 series
- EM-352
- EM-318
This cards can be fastened with four Nylon
fastening pilar which included power unit
Notice! that some of cards which mentioned
above cannot give full output power with
this power unit, because it is limited by output
of power unit.
TECHNICAL DATA | |
---|---|
Operating Voltage | 230 Vac ±10% |
Power Consumption (max.) | 85 VA |
Idle Power (typ.) | 2 W |
Fuse | T1A (5×20 mm) |
Output Voltage vs. Current | 31 Vdc (no load) |
24 Vdc at 1.5 A | |
22 Vdc at 2 A | |
20 Vdc at 3 A | |
18 Vdc at 4 A | |
15 Vdc at 5 A | |
Output Current (nom. cont. max.) | 1.5 A |
Output Power | Typ. 40 W, Peak 75 W |
Operating Ambient Temperature | -20…+50 °C |
Weight | 1.35 kg |
Dimensions | 80 × 250 × 72 mm |
Housing Material | ABS plastic |
EMC Compliance | EN-50081 / EN-50082 |