EM-337A-48V-PLI is a parallel synchro controller for 4 DC-motors. The controller has four H-bridge power stages. The driver works with actuators that can offer pulse feedback signal. The control is done with FW / BW commands. The synchronization control will keep all motors in the same speed and position. If synchronous error exceeds the set difference limit, all motors will be stopped. Device includes adjustable acceleration and deceleration ramps, which produce the smooth starts, stops and direction changes. Load compensation also enables good operation with asymmetric loads. Adjustable current limits can be set to protect motor and mechanics against overcurrent (over sized forces).
Technical Data | |
---|---|
Supply voltage | 24-48Vdc (20-58Vc) |
Undervoltage shutdown | 8V |
Overvoltage limit | 58V |
Idle current | < 20mA |
Motor current | @ 2kHz / 16kHz |
4x8A / 4x4A at continuous use | |
4x10A / 4x5A at duty cycle 25% | |
4x15A / 4x8A at duty cycle 10% (5s max) | |
4x25A max. in start | |
Current limit (setting) | 1-25A |
PWM frequency | 2kHz or 16kHz |
Input control logic levels | "NPN" ON = 0-1V, OFF = 4-30V or open |
"PNP" ON = 4-30V, OFF = 0-1V or open | |
Control input impedances | Typ. 47 or 10kΩ |
Pulse input frequency | Max. 700Hz/input channel |
Pulse inputs pull-up/down | 10kΩ |
Fault output | NPN open collector, max. 30V/50mA |
5V auxiliary output | Max. 20mA |
Position output | 0-5V (Rout 1kΩ) |
Brake output | NPN max. 4A |
Supply connectors | 4mm² |
Motor/control connectors | 2.5/1.5mm² |
Weight | 190g |
Recommended operating temperature (Ta) | -40...60°C |
Overtemp shutdown | 120°C (power stage) |
CE Electromagnetic compatibility | EN-55022B and EN 61000-6-2/-4-2...6 |
Dimension and housing options | Card: 142x73x28mm |
Installed in DIN-rail base: 145x127x50mm | |
Fibox PC150/60: 180x130x60mm | |
Fibox PC175/100: 180x180x100mm (includes 300VA supply) |