EM-295C is a one direction DC motor speed controller. The controller uses PWM principle and works high efficiency. The PWM frequency mode can be set to high or low freq .
This device has designed for speed control use. The rpm is regulated against supply voltage changes and the RxI compensation improves rpm stability at low rpm. The current limit limits the torque of motor or shutdown the motor Device has also few auxliary I/O. The output can be used for fault indication or brake control. The inputs can be used as a end limits, stop, brake or freewheel control input.
Technical Data | |
---|---|
Supply voltage | Nom. 12-48V, max. 10-58Vdc |
Overvoltage shutdown | Max. 60V (adjustable) |
Motor current (cont.) | Max 25A (Ta < 50°C & pwm 2kHz) |
Max 20A (Ta < 50°C & pwm 16kHz) | |
Motor current (peak) | Max 40A (10s) |
Voltage drop | Typ. 0.7V at full speed |
PWM frequency | 2kHz or 16kHz |
Start ramp | 0-2.5s adjustable |
Stop ramp | 0-2.5s adjustable |
Control range | 0-5V or 0-10V, adjustable |
Output range | 0-10V...0-55V |
Output 1 | NPN open collector with 2.2k pull-up |
Output 1 max. | 3A (diode for inductive load) |
Inductive output (pin 11) | PNP open collector, 12V max, 10mA |
Control input 1 | PNP, Rin 100kΩ |
Control input 2 | PNP, Rin 10kΩ |
Control input levels | Low: 0-1V, High: 4-30V |
Connectors (supply and power) | 2.5mm |
Connectors (control) | 1mm |
EMC | EN-50081-2 & EN-50082-2 (industrial) |
Weight | 80g |
Operating temperature (Ta) | -40...70°C |