EM-323 is a 1-quadrant power controller. The controller uses PWM principle with high efficiency. The PWM frequency mode can be set to high or low. High frequency is used with inductive ( motor ) load and low with resistive ( lamp ) load. The output of the device is compensated against power supply changes and there is also load compensation ( RxI ), which improves speed regulation at low speeds.
The device is controlled with an analog voltage signal 0-5V or 0-10V. Output range is adjustable. EM-323 also includes start and stop ramps for smooth operating.
Settings can be done with the serial interface unit EM-236. Connect interface unit to the red on-board connector of the device. EM-236 displays the number and version of the device. Select LOAD & EDIT with the select button and you will enter parameter editing mode. Select desired parameter with arrow buttons
and change value with (+) and (-) buttons. When you're done editing the parameters, you can save them with long push of the save button.
TECHNICAL DATA EM 324C (PCB Version v2) | |
---|---|
Supply voltage | 10-35V |
Overvoltage shutdown | 38V |
Motor current cont. max | 4A (Ta) |
Motor current peak | 8A (10s) |
Voltage drop | 0.3V at 4A |
PWM frequency | 2kHz or 16kHz |
Start ramp | 0..2.5 s, settable |
Stop ramp | 0..2.5 s, settable |
Current limit | 0.1-8A, settable |
Control range | 0-5V or 0-10V, adjustable |
Output range | 0-5V ... 0-33V, settable |
Control input impedances | 100kohm |
Fault output | NPN max. 50mA |
with SW1 can be connected to 2.2k pull-up resistor | |
Connectors (supply and power) | 1.5mm² |
Dimensions | 72x20x17mm |
Dimensions in rail base | 90x23x48mm |
Connectors (control) | 1mm² |
EMC | EN-50081-2 & EN-50082-2 (industrial) |
Weight | 30g |
Operating temp. (Ta) | -40...70°C |