EM-259A is a dimmer for 12-24V system. This device has PNP and NPN outputs, so it can be used either with positive common or negative common systems. The output can source max. 4A current. If this current is exceeded the self-recovery fuse will cut out the output. The load can be resistive or inductive, and there is a special control adjustment curve also for led lamps. The control input is isolated, which makes possible to use this device with external voltageor mA-signal. Also this device can be controlled with potentiometer. The isolated input makes it easy to connect many of these devices to work in parallel. The settings are made with dip-switches, which are located behind the side cap. The housing is rail mountable. Heat sink is on the side of the box. If load is over 3A, there should be at least 5mm free air on this side of the box to enable the cooling. Device meets the EMC requirements (CE) for household and industry use.
TECHNICAL DATA | |
---|---|
Supply Voltage | 18...35 Vdc (cont.) |
Current Consumption | 30 mA (quiescent) |
Output Range | 0-100 % |
Output Modes | PNP pull-up / NPN pull-down |
Output Current | Max. 4 A |
PWM Frequency | 250 Hz |
Voltage Drop | Max. 0.5 V |
Control | 0-5V, 0-10V, or 0-24V |
0...20mA or 4...20mA | |
Or a 1k to 10k potentiometer | |
Max. Adjustment | Max. Output 100%-50% |
Bias Adjustment | Start Level 0-50% |
Input Impedance | 100 kΩ (for voltage signal) |
100 Ω (for current signal) | |
Isolation | 500 Vdc |
Operating Temp. | 0...60°C |
Dimensions | 79 × 27 × 86 mm |
Housing | Rail mountable module (PHOENIX UEGM-25) |
Weight | 140 g |