EM-348-PLI DC-MOTOR CONTROLLER 12-24V, 15A, Rs-485, Modbus
EM-348-pli is a full bridge DC-motor starter. It is designed to work with DC-motor in applications where some special functions are needed. Starter has adjustable acceleration and deceleration ramps, which make possible the smooth starts and stops. Adjustable current limit protects motor against overcurrent and it can also be used as an end-stop. This device has also two settable speeds, which are usefull in positioning applications. Control inputs FW and BW start the forward and backward run. STOP is for the motor shut-down. In -PLI version there are also PULSE COUNTER which can be used for end limit use. This counter value keep in memory of card also when power is turned off. FAULT output terminal indicates different failure situations. This pin is normally low, but is pulled up in overheat and conditionally also in current trip situation. DISABLE input disables driver as long as this is pulled up externally. Also it is possible to link fault and disable pins of several units together and achieve a syncronous stop. The BRAKE output can be used to
release external magnetic brake or control brake resistor in overvoltage situation.
There are two selectable control modes, continuous and impulse. In continuous mode the motor runs as long as the control is active. In impulse mode a short comand starts the motor, and only a new impulse will change the status. There is also few special settings start-kick and auto reverse. The card has selectable input logics. Inputs are divided in two groups, control and limit -inputs. Groups can be individually set for NPN or PNP logic. The parameters are set with EM-236 interface unit. Operation of the controller and some of its functional values can also be monitored with EM-236 interface unit.
This device is designed to control also with Rs-485 Bus.The control bus use Modbus RTU protocol and with the Bus there can be set, speed, direction, accelaration and deceleration ramps and current limit. Also the monitoring and parameter setting are possible with the Bus. There is a separate instruction for operating the bus.
TECHNICAL DATA
Supply voltage cont. max. 10-35V
Overvoltage limit adjustable 15-40V ( hardware limitations )
Start up voltage 9V, shutdown voltage 8V
Motor current cont. max. 15A, peak max. 30A ( TaCurrent limit adjustable 0.1-20A ( at start max 30A )
Overheat limit 100°C
Start and stop ramp adjustable 0-5s
PWM frequency 2kHz
Speed input scale ( speed-2 ) 0-5V = 0-100% pwm
Input control logic: high =4-30V, low=0-1V
Control input impedances typ. 47kohm
Pulse input imped. typ 10kohm
Pulse input freq max. 400Hz
Control input response time typ 5ms.
Fault out. PNP open coll. 12-22V / max. 50mA
Fault/ disable in activation Uin > 4V ( PNP )
Brake output NPN 1.5A max. 35V
Motor and supply connectors 2.5mm
Control connectors 1mm
Dimensions 42x72x25mm
Dimensions in DIN-rail base 45x80x45mm
CE-tested for industrial environment ( emc )
Operating temp ( Ta ) -40...60°C
Weight 75g
Product files
- EN_em-348-PLI.pdf - Download product file (1240 kb)
- Modbus_common_part_10.2.2021.pdf - Download product file (393 kb)
- Modbus_PLI_12.6.2019.pdf - Download product file (183 kb)
- EN_em-Rail_bases.pdf - Download product file (2834 kb)
Stock
- 159 pcs. in stock
Price
-
59,00 € /unit