EM-236A Interface Unit
EM-236A Interface unit is made for adjusting and copying adjustments of Electromen driver devices and for monitoring dynamic values during drive. EM-236A enables the searching of the right settings and adjustments for the application, and after that these settings can be reliably loaded to other units.
EM-236A is handy in instrumentation and also a simple tool in production.
The use in short:
After the driver unit is powered the cable from EM-236A with red "Micro Match" connector is connected to the driver unit, (Notice the hole in board for polarity tab). The display of interface unit wakes up and after some announcements it is ready to load up parameters from the target driver (Load&Edit), if there is need to
edit, the values can be changed with + and - buttons. Then the parameters can be saved with 2 seconds push of the "2sec. save" button. If the operation of the driver is OK. the red connector can be connected to the next driver and with a push of "Copy to device" button the same parameters are loaded to the next unit
and to as many units as the user desires.
Supply: 3-6V / 30mA
Baud rate: 9600b/s ±10%
Display: 2x16digits, LCD
Memory: 5 slots, each can store
one set of parameters.
Lead length: 23cm
- Please send an enquiry.
39,00 € /unit