EM-324-SAF POSITIONING DRIVER 12-24V 4A
EM-324-SAF is a positioning driver to be used with DC-motors. The solid state power stage operates with high efficiency as it is realized with FET-transistors. Its literally everlasting compared to relay solutions. Control and feedback is done with analog signal. Control signal can be a voltage in range of 0 to 11V or current from 0 to 20mA. Feedback signal can be in the range from 0 to 11V. Driver supports also a potentiometer feedback, with auxiliary voltage outputs of 0V and 5,5V to exitate the potentiometer. The max. accuracy available for positioningof is 0,2% that is adequate for most actuator positioning applications.
The settings and adjustments are done with parameters as in all new generation Electromen products. Movement range can be modified from both ends with SW-limit parameters. Current limits and driving speeds can be set individually for both directions. Driver includes also many other dynamic adjustment possibilities like parameters for load compensation, dead-zone setting (positioning window), start and stop ramps for a smooth direction change and braking zone for well operating positioning.
The parameter setting and status monitoring is done with EM-236 Interface Unit. With EM-236 the right parameters can also be easily copied to other driver units. The on-board LED-light indicates the possible fault situations with blinking codes. If needed, the fault can be forwarded trough combiport to other driver cards. Alternatively this port can be set to give out the "position OK" information or it can even indicate the position with an analog voltage signal. Device is EMC tested for industrial and household environment and operating temperature range is quite wide.
There are also some housing options available for EM-241-SAF driver card.
TECHNICAL DATA
Supply voltage 10-35V
Shut down voltage 8V
Power up voltage 9V
Motor current cont. 4A at 2kHz / 3A at 16kHz mom. 6A ( TaCurrent limit 0.1-6A ( in start max. 8A )
Overtemp. limit 100°C
PWM frequency 2kHz / 16kHz
Analog feedback ranges 0-5V / 0-10V
Control input ranges (position) 0-5,5V / 0-11V / 4-20mA
Positioning potentiometer 10k recom. 22k max.
Input resistor for mA-signal 250ohm (socket on board)
Position out. signal range 0-5V or 0.5 - 4.5V, 0V for FAULT
Digital input levels high =4-30V, low=0-1V
Digital input impedances typ. 47kohm
Limit-FW / -BW and pulse inputs imp. typ 10kohm
COMBIPORT pin.13
- Fault output, NPN, open coll. max 30V / 50mA
- Disable input Uin < 1V ( NPN )
- position output impedance 1kohm
Connectors for motor and supply max. 1mm² cable
Connectors for signals max. 1mm² cable
Operating temp( Ta ) -40...60°C
Dimensions 72x32x25mm
Weight 80g
CE-tested for household and EN-55022B,
industrial environment (EMC) EN-61000-4-3, -4, -5, -6 passed
Product files
- EN_em-324-SAF.pdf - Download product file (178 kb)
- EN_em-Rail_bases.pdf - Download product file (2834 kb)
Stock
- 14 pcs. in stock
Price
-
34,00 € /unit